Here is a tested Arduino project that uses 3 sensor probes as water level indicator with 3 leds and one LCD display + a simple controller that turns on a motor when the water has reached the desired ...

When the sensor detects that the moisture content is already below 30%, it sends a signal to the Arduino, which, in turn, activates a water pump to provide hydration to the plant.

If the water is somewhat low, the Arduino-controlled relay powering the tree is switched off and then on again, every 5 seconds. If the base is nearly dry, the tree asks for water by blinking the ...

This is a simple arduino project for a soil moisture sensor that will light up a LED at a certain moisture level. It uses Arduino Duemilanove microcontroller board. Two wires placed in the soil pot ...

I've just come across a no-name non-contact, high-precision 80 GHz mmWave radar sensor for liquid level detection with a 40m ...

The device consists of an Arduino hooked up to a cheap flow meter sourced from Banggood. The sensor consists of a paddle wheel that sits in the water flow, fitted with a magnet.

I was thinking there must be a simple sensor that could tell me when the water level has fallen a set amount and automatically run the "fill pool" zone on the Rachio.